25 pcs Metal Pin Caps, Pinheads, Screed Pipe Chairs 2",Concrete Tools, Fittings, Yokes, Easy Screed System

Red Line Manufacturing

Metal Screed Chairs are used to hold a 2” OD or smaller metal pipe to create a temporary rail at concrete grade for your screed to ride on. This will help to give you a flatter more accurate finished product. Our Screed Chairs are manufactured in the USA from metal that is manufactured in the USA. Metal Screed Chairs are virtually indestructible and can be used over and over again. Metal Screed Chairs are used when pouring up against a building or a wall or when the pad you are pouring is wider than your screed, you can set them in the center to hold a metal pipe at grade to screed off of. A Must for garage floors, basement floors, shop floors, and all concrete pad sizes. They can be used when pouring footings to give you a perfectly flat footing surface without having to use forms (see instructional videos). Metal Screed Chairs can also be used to help get your subgrade to perfect levels. Used for gravel leveling for concrete pads, or sand base leveling for patio or brick pavers, or even used for leveling dirt for landscaped areas (see instructional videos). To use Metal Screed Chairs you must first set a stringline to finished grade. If your pouring next to a wall you need to keep the stringline about 12" to 16" away from the wall to leave room for your screed to move. Next you need to cut 1/2" rebar to 18" - 24" in length. Drive those rebars about a half inch to one inch away from the stringline every 3'-4' apart. International products have separate terms, are sold from abroad and may differ from local products, including fit, age ratings, and language of product, labeling or instructions., Weight: 1.0 pounds, Manufacturer: World Wide Manufacturing