C1101X 2 Pin for JST-XH Male to Compatible Tamiya Male 20AWG 20cm Silicone Wire

Name: C1101X 2 Pin for JST-XH Male to Compatible Tamiya Male 20AWG 20cm Silicone Wire
Brand: BSP

BSP

2 Pin JST-XH Male to (Large) Tamiya Male 20AWG 20cm \n \nSimple convertor cable. \n \nJST-XH Male (male housing) to Tamiya 'Large' Male (using female internal pins).\n20AWG silicone wire 20cm long. \n \nNote this cable does not feature any kind of resistor / chip or voltage regulator (simply just wires and connector) so please ensure your using the correct voltage for the equipment your converting connections.\n\nHow to check polarity?\n\n \n\nQuickest\n and most simple check is to ensure that your black wires simple run \nparallel with your red wires throughout the connector (example below - \nnote picture below is for illustration only to show how the wires should\n look if correctly connected - parts pictured below are not for sale in \nthis listing).\n\n \n\n \n\nIf\n for some reason your red wire runs through the connector with a black \nwire connecting where the red wire should be on the other side then you \nwill have an issue with polarity. ;