Bondit Anchor Bond, Resin Mortar Anchor System, GREY 400ml

Bond It

Description:A polyester resin, 2‐part, rapid curing, chemical anchoring system. Applied in one single action to produce a costeffective, tough chemical resistant fixing.UsesSuitable for setting bolts, studs, wall ties, starter bars or largescrews, etc into a wide range of substrates. Compatible withbrickwork, concrete, masonry, stone and PFA blocks. Hollow basematerials can also be securely fastened using ANCHOR BOND inconjunction with a sleeve or sieve.Chemically resistant, waterproof and vibration proof.PreparationDrill a hole to the correct diameter and depth (see chart overleaf), ideally using a rotary percussion machine. For optimumresults the wall sides should be thoroughly roughened. Clean holeand remove all dust and debris using a hand air pump or a stiffrotary brush, if required.All bars should be clean and free from oil or grease and all flakingrust should be removed. Threaded rods or studs should be chiselended to prevent them being unscrewed from the cured resin.ApplicationScrew the mixing nozzle on to the cartridge (hand tighten). Placethe ANCHOR BOND cartridge into the dispensing gun. Squeeze thehand trigger a few times until material passes through the mixingnozzle. Allow the material to flow until an even colour is obtained(normally 5-6 inches). Insert the nozzle into the base of the holeand extrude material, half filling the hole with resin. Withdraw thenozzle then insert the fixing into the filled hole, slowly rotating tofully coat the surface. After application release the pressure fromthe dispensing gun.