Operational Amplifier Testing Module Board OP AMP Tester High Low Speed Diffe ;;
Feature: \n 1. TEST OBJECT: T2 upgrade OP AMP testing board can be used to test common chips for single OP AMP, double OP AMP and quad OP AMP. The circuit board can determine whether the IC can be used for amplification, and the conversion rate of the chip, can also identify low speed chips that in the disguise of as high speed chips\n2. MEASURABLE PARAMETERS: Measurable conversion rate, static current, DC offset, etc. The distinction between high speed and low speed operational amplifiers is clear, and their performance is immediately apparent. Equipped with test terminals, can test static current\n3. OUTPUT MODE: For high speed OP AMP, can output normally when input high and low frequency signal, as the corresponding red LED and green LED synchronization, steady on(200KHZ) or bright (10HZ)\n4. OUTPUT DISPLAY: For low speed OP AMP, when input signal, the output end can not complete the output waveform, as shown by the corresponding red LED can not be lit normally, only one or two ar:
Compare prices (1 shop)
| shop | Price | Action |
|---|---|---|
|
11,78 GBP | Go to shop |
