Network Relay Module RTU 1 Way Wired Ethernet LAN Control PCB Electronic

--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n--\n\nFeature: \n 1. CHIP AND SPEED: Network relay module carries mature and stable 32bit MCU STM32F103C6T6 chip, W5500 all hardware D CP or P protocol stack Ethernet chip, supporting 10/100M bps rate\n2. TECHNICAL PARAMETERS: Network relay module supports standard RTU protocol. The flute serves as the Server and supports the IP address DHCP function. The port number is 5000. You can view the module IP address through the serial port. The baud rate of UART communication is 115200\n3. OUTPUT SIGNAL: The relay switch signal supports manual, flashover closure, flashover mode. The delay base of flashover closure or flashover is 0.1S, and the maximum flashover closure or flashover time can be set as 0xFFFFx0.15=6553.5Ss\n4. SAVE AND READ: The device address ranges from 1 to 255, the default address is 255, which can be saved after power failure. The relay status and device address can be read using software or instructio-