Lay Z Spa Aluminium PTC Heating Element AC230V 2000W Heater Hot Tub - New Seals

Name: Lay Z Spa Aluminium PTC Heating Element AC230V 2000W Heater Hot Tub - New Seals
Brand: Lay-Z-Spa

Lay-Z-Spa

PTC Heating Element - Aluminium - AC230V 2000W\n\nBestway Lay-Z-Spa AirJet Pumps\n\nRefurbished, Fully Tested & Ready for Installation\n\nCommon Problems\n\nPower tripping when the heater is enabled? Typically indicates an element fault to ground or a dead short, causing the PRCD / GFCI or house breaker to activate for safety.\n\nSlow to Heat, or never quite reaching the target temperature? A correctly functioning heater should typically increase temperature by approximately 1\u00B0C (1.8\u00B0F) per hour, depending on ambient conditions. If the unit is slow to heat or fails to reach the set temperature, common causes include a failed heater element, a logic control fault preventing the heater from powering on, or a degraded flow sensor. You are welcome to contact us for assistance with diagnosis.\n\nNo Heat? This is most commonly cause by the target temperature being set too low or failure to enable the heater on the control panel. It can also be caused by a blown thermal fd